Product Features: :
Supports VAG-COM version 409.1 or older
Fully automatic support for 2002+ Audi models with dual K-lines
High quality precision moulded diagnostic connector made to fit all Audi/VW vehicles
LED light shows cable communication status
Fully CE approved
In-built electronic protection from 'aftermarket radio problems'
This purchase is for one 145cm long, 16 pin OBD diagnostic socket to RS232 9 pin interface cable with USB connector
----This diagnostic cable is usable for ISO9141 and KWP2000 transmission protocol (16pin OBD II style Data Link Connector).
----This cable can not work if your car uses a protocol/bussystem like VPW, PWM or CAN-bus.
----Terminal K = Bus of communication
----Terminal L = Ignition for waking up car computing system (ECU: Engine Control Unit)
----Existed 3 different protocols with same OBD2 connector incl. ISO/KWP, VPW, PMW
----This K/L Diagnostic interface & cables work on ISO/KWP (Key Word Protocol) launched after 1996 only.
----Supported also ISO9141 protocol
----The Cables may work with some versions of the Carsoft, but carsoft used a lot of different interfaces during the different versions and also had some custom interfaces.
VAG-COM is a Windows based diagnostic software for Volkswagen, Audi, Seat and Skoda vehicles that emulates the functions of expensive professional scan tools. It is:
----Fully compatible with all models of the above makes of car or van produced between 1996 and 2006 (see below for more information on earlier models)
----Compatible with the above makes of car with CAN connection
----Has a data base of more than 7500 fault codes and measuring block texts
----Can use the new 7 digit PIN/SKC codes to match new keys in all immobilizer-equipped W, Audi, Seat and Skoda models
----VAG software: Versions: 3xx, 4xx, (THIS CABLE NOT SUPPORT CAN-BUS)
----ShadeTree Software ProDiag 1.0x (for PalmOS) Serial Cable:
----(A)Palm III, Palm V/Vx, Palm VII, HandSpring Visor Series, HandEra TRG, SONY
----(B)PDA to Serial converter cables available
----VAG Diagnose (for DOS): Supports powerful Direct Memory Access (DMA) which allows users to modify RAM/EEPROM/SEEPROM directly through the cable without ever touching the controller cover
----REVO Lemmiwinks ECU Tuning
----APR Immobilizer Information Reader
----ECU Tuning Applications
----Other VW diagnose/tuning software
Cable Length: 141 cm
Weight: 122 g
NOTE: The item and software could work with Windows 2000 and Windows XP only.
1 x OBD-II Interface
* 1 x CD Disk